Connection error: Failed to connect. Is the cable connected?

[nature]

i have Read all the information, all programs tested, but only one result:
--------------------
Console Companion
Connection error: Failed to connect. Is the cable connected?
---------------------------------------------------------------------------
iPhone5, iOS 6.1.4 , get console v.1.95
-------------------------------------------
Bought last week Airconsole Pro Single I hope to get help.

Power charging is complete.
Connection method:
airconsole --> USB Connector --> RJ45-to-DB9 Adaptor -->PC (HP Compaq 6380 Pro) COM1

WIFI is very easy to connect, but after connecting to the PC serial, in any case not be able to connect to the serial port,

replied:

Console Companion
Connection error: Failed to connect. Is the cable connected?

a Amateur Radio HAM, Need Help.

73!

[R4+Z]

I think you are in the same boat as me. If you try using Get Console on your iphone or Ipad and use CTS/RTS flow control, you may see a result. I have been unable to get round the problem with a PC connection though. I have made up my own converter lead and tried strapping the CTS to the RTS which should bypass the need for the flow control but that didn't work, I have also tried browsing into the air console and setting CTS/RTS flow control but still no coms.

I'm beginning to think I may have to send it back!

[simon]

The "Console Companion Connection error: Failed to connect. Is the cable connected?" is an error you get when Get Console is trying to connect to a Redpark cable that is not connected to the iPhone / iPad.

Airconsole Cable Error

Screen Shot 2013-10-03 at 5.24.41 PM.png (18.96 KiB) Viewed 44975 times

The error you get with nothing connected to Airconsole is slightly different: it will say "Console Companion: Connection Error - Check serial cable is connected to Airconsole Device"

Airconsole Cable Error

Screen Shot 2013-10-03 at 5.24.41 PM.png (18.96 KiB) Viewed 44975 times

If you are launching a saved connection it might be defaulting to using a Cable in "Connect with". you can change this to "Airconsole" and save it. Otherwise if you try to connect in Get Console via Quick connect (plus button) ->Serial, does the "Connect with:" field show "Airconsole" in Green?

Quick Connect Airconsole

Screen Shot 2013-10-03 at 5.29.44 PM.png (65.74 KiB) Viewed 44975 times

If so, and the failure message is as per attached the message you are receiving indicates Get Console can see and talk to the Airconsole adaptor, but there is no mounted tty line connected to Airconsole. This could be because you have a faulty Airconsole USB port, or the USB cable is faulty (there are active electronics in the USB to RJ45 cable - you need to use this cable that comes with Airconsole).

[nature]

Thank you very much to answer the problem has been solved.
I've AirConsole embedded into my machine to solve supply problems for a long time.

[Cagatey01]

The most reliable method to change the SSID - After you change the SSID in Wireless settings, you need to apply the settings, wait and then (generally) reboot the air console by turning it off then on again. Wait until the blue light is blinking again for about 10 seconds and then scan for new WIFI networks. Please let me know if that works.

_______________________
http://www.win-on-slots.com/

[nature]

Thank you very much, now the problem has been completely solved.

I use in the field of plant ecological monitoring, the sensor signal transmission through the network back to the office.

However, the "Private Server" I always wish to use. But do not use.