ELMO GMAS usb-serial drivers.

Post Requests for new features and product roadmap here

Moderator: sergey

Flange_Gasket
Posts: 28
Joined: Tue Mar 04, 2014 2:39 pm

ELMO GMAS usb-serial drivers.

Postby Flange_Gasket » Fri Mar 20, 2015 2:22 pm

The new AMX NX series controllers have a USB program port that installs on Windows as a ELMO GMAS driver. Is there any support for this in Airconsole? I have tried but I can't get it to work.

daniel
Posts: 127
Joined: Wed Jul 27, 2011 9:33 am

Re: ELMO GMAS usb-serial drivers.

Postby daniel » Fri Mar 20, 2015 3:32 pm

The port is most likely a CDC-ACM port with a custom VID/PID. In which case it won't be picked up by the Airconsole

Is it possible for you to advise the reported VID/PID? If you connect it to the Airconsole USB port, log in via telnet and issue the following command:

Code: Select all

cat /proc/bus/usb/devices


You can then post it here or email to support@get-console.com and we will see if we can add it into the next firmware release.

Flange_Gasket
Posts: 28
Joined: Tue Mar 04, 2014 2:39 pm

Re: ELMO GMAS usb-serial drivers.

Postby Flange_Gasket » Fri Mar 20, 2015 4:56 pm

daniel wrote:The port is most likely a CDC-ACM port with a custom VID/PID. In which case it won't be picked up by the Airconsole

Is it possible for you to advise the reported VID/PID? If you connect it to the Airconsole USB port, log in via telnet and issue the following command:

Code: Select all

cat /proc/bus/usb/devices


You can then post it here or email to support@get-console.com and we will see if we can add it into the next firmware release.


Hi Daniel,

Thanks for the reply.
Vendor = 0525
Product ID = a4a7

I've attached a screenshot of it too.

Regards
Mark.
Attachments
ac.jpg
ac.jpg (50.05 KiB) Viewed 47822 times


Return to “Feature Requests”

Who is online

Users browsing this forum: No registered users and 22 guests