ELMO GMAS usb-serial drivers.
Moderator: sergey
-
- Posts: 28
- Joined: Tue Mar 04, 2014 2:39 pm
ELMO GMAS usb-serial drivers.
The new AMX NX series controllers have a USB program port that installs on Windows as a ELMO GMAS driver. Is there any support for this in Airconsole? I have tried but I can't get it to work.
Re: ELMO GMAS usb-serial drivers.
The port is most likely a CDC-ACM port with a custom VID/PID. In which case it won't be picked up by the Airconsole
Is it possible for you to advise the reported VID/PID? If you connect it to the Airconsole USB port, log in via telnet and issue the following command:
You can then post it here or email to support@get-console.com and we will see if we can add it into the next firmware release.
Is it possible for you to advise the reported VID/PID? If you connect it to the Airconsole USB port, log in via telnet and issue the following command:
Code: Select all
cat /proc/bus/usb/devices
You can then post it here or email to support@get-console.com and we will see if we can add it into the next firmware release.
-
- Posts: 28
- Joined: Tue Mar 04, 2014 2:39 pm
Re: ELMO GMAS usb-serial drivers.
daniel wrote:The port is most likely a CDC-ACM port with a custom VID/PID. In which case it won't be picked up by the Airconsole
Is it possible for you to advise the reported VID/PID? If you connect it to the Airconsole USB port, log in via telnet and issue the following command:Code: Select all
cat /proc/bus/usb/devices
You can then post it here or email to support@get-console.com and we will see if we can add it into the next firmware release.
Hi Daniel,
Thanks for the reply.
Vendor = 0525
Product ID = a4a7
I've attached a screenshot of it too.
Regards
Mark.
- Attachments
-
- ac.jpg (50.05 KiB) Viewed 49980 times
Who is online
Users browsing this forum: No registered users and 7 guests