Text very low on the screen

Read the Updated Get Console FAQ Here, and post additional Questions that we should be answering

Moderator: sergey

mnilsson
Posts: 1
Joined: Wed Jan 22, 2014 9:33 am

Text very low on the screen

Postby mnilsson » Wed Jan 22, 2014 9:42 am

Hi,
I'm using the app and serial mode to connect to a PLC. It works fine but the output text is situated very low on the Ipad screen, partly covered by the virtual keyboard. Are there any parameters that be changed to move the output text to the top of the screen?

//Mats

simon
Site Admin
Posts: 158
Joined: Mon Jun 06, 2011 2:48 pm

Re: Text very low on the screen

Postby simon » Fri Jan 31, 2014 8:40 am

you can change where the active line of text appears on the screen by pressing the keyboard button on the top bar. This cycles through the keyboard being up, down or transparent.

If even when keyboard is up the active line is below the keyboard bar, then rotate the iPad to horizontal and back to portrait and it should correct.

Thanks
Simon

chris
Posts: 34
Joined: Tue Feb 25, 2014 3:05 am

Re: Text very low on the screen

Postby chris » Thu Aug 28, 2014 3:49 am

Would it be possible to have get-console default to having the bottom line of text situated above the keyboard and shortcut bar, when using an opaque keyboard? When I connect to a device the first time, it is a pain to press through the transparencies and rotate the iPad back and forth.


Return to “FAQ”

Who is online

Users browsing this forum: No registered users and 11 guests