Hi,
I'm using the app and serial mode to connect to a PLC. It works fine but the output text is situated very low on the Ipad screen, partly covered by the virtual keyboard. Are there any parameters that be changed to move the output text to the top of the screen?
//Mats
Text very low on the screen
Moderator: sergey
Re: Text very low on the screen
you can change where the active line of text appears on the screen by pressing the keyboard button on the top bar. This cycles through the keyboard being up, down or transparent.
If even when keyboard is up the active line is below the keyboard bar, then rotate the iPad to horizontal and back to portrait and it should correct.
Thanks
Simon
If even when keyboard is up the active line is below the keyboard bar, then rotate the iPad to horizontal and back to portrait and it should correct.
Thanks
Simon
Re: Text very low on the screen
Would it be possible to have get-console default to having the bottom line of text situated above the keyboard and shortcut bar, when using an opaque keyboard? When I connect to a device the first time, it is a pain to press through the transparencies and rotate the iPad back and forth.
Who is online
Users browsing this forum: No registered users and 1 guest