How to bridge between wired and wireless network?

Questions, FAQ, Feature Requests and Troubleshooting for Airconsole

Moderator: sergey

kwok
Posts: 13
Joined: Fri Sep 13, 2013 3:06 am

How to bridge between wired and wireless network?

Postby kwok » Sun Jan 25, 2015 6:43 pm

I'd like to use airconsole to bridge between a wired network (device management LAN) and the airconsole wireless network.

I have setup my AC with a static IP like 192.168.101.1 but the devices which I want to connect via the AC LAN can be of any static IP like 126.120.70.55.

Is there a way to configure the AC perhaps using static route, so that I can achieve the above?

daniel
Posts: 127
Joined: Wed Jul 27, 2011 9:33 am

Re: How to bridge between wired and wireless network?

Postby daniel » Mon Jan 26, 2015 8:30 am

I think you are talking about a routed interface rather than an ethernet level bridge (by default the Airconsole runs a bridge between the physical LAN interface and the built-in WiFi AP interface). See the Airconsole manual for more details - http://support.get-console.com/

To add a static route go to the routing tab on the Airconsole web interface.

kwok
Posts: 13
Joined: Fri Sep 13, 2013 3:06 am

Re: How to bridge between wired and wireless network?

Postby kwok » Mon Jan 26, 2015 2:51 pm

Hi Daniel,

I'm not too familiar with network routing so whatever works will be fine. Is it technically possible to achieve my goal of communicating with the device management LAN (e.g. 126.120.70.55) when my AC is set with a static IP of 192.168.101.1 ?


Return to “Airconsole”

Who is online

Users browsing this forum: No registered users and 6 guests