Firmware Upgrade to 2.03 ended with an error
Posted: Fri Mar 14, 2014 12:56 pm
I did a upgrade exactly as described in the instructions to 2.03
It ended up with an unknown error, see screenshot
I was frightened that I had to return the unit but I'm lucky,
after a power-cycle the Console works OK !!
It ended up with an unknown error, see screenshot
I was frightened that I had to return the unit but I'm lucky,
after a power-cycle the Console works OK !!
You can get that error if you refresh the page while the firmware is loading, but as you discovered it still actually works fine. Phew.